
Service Modes, Error Codes, and Fault Finding
5.
Also supported in this chassis:
The display option code can be changed by “062598 HOME
XXX” special SAM command (XXX=display option in 3 digits).
5.9
Software Upgrading
Always check for the latest software version in relation to
the correct CTN. Refer to the service website.
5.9.1
Introduction
The set software and security keys are stored in an EMMC
Flash, which is connected to the Marvell processor.
The user can upgrade the main software via the USB port.
This allows replacement of a software image in a stand alone
set, without the need of an E-JTAG debugger.
For a description on how to upgrade the main software refer to
the electronic User Manual (eUM).
Important: When the EMMC IC device is to be replaced, a new
SSB must be ordered, due to the presence of the security keys!
(CI +, MAC address, ...).
Perform the following actions after SSB replacement:
1.
Set the correct option numbers (see rear cover sticker).
2.
Update the TV software => refer to the instructions in the
electronic User Manual (eUM).
3.
Perform the alignments as described in chapter 6 (section
4.
Check in CSM if Set type and MAC address are valid.
When ordering a new SSB, always refer to the Spare Parts list
to use the correct order number!
5.9.2
Main Software Upgrade
Automatic Software Upgrade
In “normal” conditions, so when there is no major problem with
the TV, the main software and the default software upgrade
application can be upgraded with the “AUTORUN.UPG” from
the “Philips” P4C/S website. This can also be done by the
consumers themselves, but they will have to get their software
from the commercial Philips website or via the Software Update
Assistant in the user menu (see eUM). The “autorun.upg” file
must be placed in the root of the USB stick.
How to upgrade:
1.
Copy “AUTORUN.UPG” to the root of the USB stick.
2.
Make sure the set is operational and insert the USB stick.
The set will restart, then the upgrading will start
automatically.
3.
As soon as the programming is finished, a message is
shown to remove the USB stick and to restart the set.
5.9.3
Content and Usage of the One-Zip Software File
Below the content of the One-Zip file is explained, and
instructions on how and when to use it.
•
FullUpgrade_AND1E_x.x.x.x.zip. Contains the “upg” file
which is needed to upgrade the TV main software and the
standby software at once.
•
PQFPGA_AND1E_x.x.x.x.zip. Contains the BLCtrlµP
software in “upg” format.SW version available in CSM 2.5
PQ back-end software version.
•
NovatekAfterburner314_AND1E_x.x.x.x.zip. Contains
the software in “upg” format to drive the Novatek 72314
(Frame Rate Convertor) device.SW version in CSM 2.6 NT
72314 software.
•
RF4CE_AND1E_x.x.x.x.zip.Contains the software in
“upg” format to drive the RF4CE device.SW version
available in CSM 2.9
•
UHDFPGA_AND1E_x.x.x.x.zip.SW version available in
CSM 2.11
•
ProcessNVM_AND1E_x.x.x.x.zip. Default NVM content.
Must be programmed via USB, be aware that all
alignments stored in NVM are overwritten here.
5.9.4
UART logging 2K13 (see section “
).