Philips IS 5022 Mark II, Инструкция по эксплуатации

Страница: 14 / 42

mu 44.1
(F11)
sets
the
output sample rate to 44.1 kHz instead of the default
48 kHz. When the
LED
in the push button is off, the sample rate is
48
kHz.
Pressing the switch a
second time
reverts the output sample
rate
back to 48 kHz. In order to minimize noise
during switching,
the
change over is implemented via an
automatic
“ m u t e ” . Consequently
switching between sample
rates
is not instantaneous. In order to mini ‑
mize the risk of accidental switching of the sample
rate
a delay
has
been built in. The select button
m u s t
be pressed for about a second
before the switch is made.
EFFECTS OFF (F12)
switches
out
the active
effects.
It
can
be
used
to
make a comparison with the raw audio, and thus hear the influence of
the active
effects and
settings. When the button is pressed a second
time the effects become active again. If used while an effect LED is
flashing, only that particular effect
will
be toggled off.
Note: If the Sound Enhancer is switched o f f all settings
are
saved a n d
will be available n e x t time the unit is switched on again. If the Sound
Enhancer is switched o f f while the EFFECT OFF control is active all
settings a n d effects are lost when the S o u n d Enhancer is
n e x t
switched on.
The
n e x t group
of switches is used to select,
adjust, and activate the
effects.
=
SELECT (F13)
comprises t w o white push button switches that are used
to sequentially step through the effects:
SCRATCH BASS
NOISE TREBLE
STEREO ENHANCEMENT SPATIAL
COMPRESS/EXPAND
FADER
The A switch steps forward through the effects and the W switch
steps
backwards. The selected effect is indicated by its
LED
flashing and the
LED
bar will indicate the level of adjustment. Once the
SELECT
button
is touched, there is a six second
period to start adjusting the setting
(see b e l o w ) .
If no adjustment is made the LED bar will
revert
to indicat ‑
ing the audio level.
ADJUST (F14)
comprises
t w o
red push button
switches
that are used to
set the level for the selected effect
(indicated by
the LED flashing).
When either of these switches is pressed the selected effect will be
activated with the set adjustment.
The “ + ” button increases the effect level and the “ - ” button decreases
it. The effect level selected is indicated by the
LED
bars.
When no further adjustment is made for six seconds, the effect
LED
stops
flashing and stays on.