Philips IS 5022 Mark II, Инструкция по эксплуатации

Страница: 16 / 42

The
rear
panel contains the input and
o u t p u t
connectors. For references
in brackets, e.g.
(B1),
refer to figure 3.2.
=
WORD CLOCK (B1)
is a
BNC
connector to which an external word clock
signal can be connected for use instead of the Sound Enhancer’s inter ‑
nal clock.
=
AES/EBU IN and
OUT
(B2)
are t w o audio connectors
(XLR).
The digital
input signal
m u s t
conform
with
IEC
958. Any sample
rate
frequency
between 15 and 50 kHz can be used. No adjustment of the Sound
Enhancer is necessary for different input sample rates. The digital
out ‑
p u t signal conforms
with
IEC
958.
=
DIG
AES/SPDIF
(B3)
is a t w o position slider switch used to select either
the
AES/EBU
(B2)
input, or the SPDIF input
(B8).
m
ANALOG
BALANCED L-IN & R-IN
(B4)
are t w o XLR connectors
for the
input
of balanced analog line-in
stereo
signals.
=m
ANALOG
BALANCED/UNBALANCED
(B5)
is a t w o position slider switch
used to select either the analog balanced
(B4)
input,
or the unbalanced
input
(B7).
ms ANALOG BALANCED L-OUT & R-OUT (B6) are t w o XLR connectors
for the
o u t p u t
of balanced analog line-out signals.
m= ANALOG
OUT/IN (B7) are four Cinch connectors for
the
input and
out ‑
put
of unbalanced
analog line-in
and line-out stereo signals.
=
DIGITAL
IN
(SPDIF)
(B8) t w o
Cinch connectors are provided. The
t o p
connector is the input, the lower is only a feed through, this
m a y
sim ‑
plify certain installations.
Maximum
of t w o Sound Enhancers m a y be
connected to
one
digital source.
m
DIGITAL OUT (SPDIF) (B9)
t w o
Cinch connectors are provided.
POWER SUPPLY
DCIN
(B10)
is
the
power input from the mains adapter.
m AUXILIARY
CONNECTOR (B11)
on
the rear panel
has been prepared
for
an additional mini-DIN
connector
to
facilitate the
installation of
future
options e.g. remote control, RS232, etc.