Philips HD5720/30, Руководство по обслуживанию

Страница: 2 / 23

HD5720/30
2-23
- Now remove on both sides the upper and lower screws
where the control panel is fixed to the frame!
See picture for positions.
Remove upper screws
on both sides
Remove lower screws
on both sides for
removing the control panel
- Remove the steam knob assy, by using a tool to gently push
the steam knob assy from behind.
- Now you are able to remove the control panel.
- The control panel is electrical connected to the machine by
the band cable connection.
- The topcover can be taken of.
Remove the service door:
- The service door can simply be removed by removing the
steel wire located on the left side at the hinge.
- Pull the wire out the hinge and the service door can be
taken away.
Remove bottom cover:
- To reach the micro switch that detects the presence of the
Coffee ground container, the bottom cover has therefore to
be removed.
- At the bottom of the appliance unscrew 7 Torx screws and
remove the cover, micro switch and the lift drive belt can be
reached easily.
- If the above steps are carried out all the parts can be reached
and if needed dismantled/replaced.
For your safety, be sure the plug is
disconnected from the mains!
- In below steps the dismantling from the appliance has been
written down in a certain sequence.
Please follow the steps in this order.
Remove back panel:
- To remove the back panel, first remove the 5 screws,
see picture for positions.
- Slightly lift the back panel upwards.
- The back panel becomes loose.
- After the back panel has been removed, the way is free to
remove the other panels as well.
Remove left or right panel:
- To remove the left/right panel, slightly move the side panel
±
1 cm backwards and then remove the panel sideward.
Remove to Control panel:
- Open bean lid, remove cap from the grinder adjustment
knob and remove the screw at the inside of the Grinder
Coffee coarseness adjustment knob.
- Mark carefully the position of the knob, before removing it.
(to ensure the right position when re-assembling)
- Remove the left upper screw seen from the back and remove
the screw in the upper corner of the right side, see picture
for the positions.
Screw upper
left backside Screw upper
corner right panel
DISASSEMBLY- AND RE-ASSEMBLY ADVISE
!