Philips HD5720/30, Руководство по обслуживанию

Страница: 8 / 23

HD5720/30
8-23
PUTTING THE APPLIANCE INTO SERVICE/TEST MODE
MENU OK
OFF
ON
1. Disconnect the appliance from mains.
2. Press simultaneously
and Coffee buttons.
3. Connect the appliance to mains.
4. If above steps succeeded the display will show the following message
“LOAD TEST MODE”
Using the functions in the Service/test mode.
When the Service/test mode is entered, the following functions can be carried out / checked.
Function selection Action to perform Display message Result of the action
1. Operate Brewing
Heater Push the MENU
button HEATER ON Close steam knob!!! **
The Brewing heater will be powered, check
power consumption (
±
1240 W). *
2. Operate Pump
Push the
button
PUMP ON If water container is fi lled, placed and steam
knob is closed ** the pump will be powered
(
±
40 W).
3. Operate the grinder Push the OK button GRINDER ON Close steam knob!!! **
Grinder will grind “Beans”.
4. Operate Brewing unit
upwards (motor lift) Push the On/OFF
button MOTOR UP
&
LIMIT SWITCH
UP
If this function will be performed always
be sure the Brewing unit has been installed,
service door is closed & Coffee ground
container is in place.
If the
brewing unit_up_position M1
has been activated by the Brewing unit
the Display will show message LIMIT
SWITCH UP.
5. Operate Brewing unit
down (motor lift)
Push the
button
MOTOR DOWN
&
LIMIT SWITCH
DOWN
If this function will be performed always
be sure the Brewing unit has been installed,
service door is closed & Coffee ground
container is in place.
If the
brewing unit_down_position M2
has been activated by the Brewing unit
the Display will show message LIMIT
SWITCH DOWN.
6. Operate discharge valve
(EV1)
Push the button
EV1 ON Close steam knob!!! **
The 3way discharge valve will be powered.
7. Operate steam Heater
Push the button
VAPORIZER ON You will have to turn the steam knob
fully open, before the steam heater will be
powered!
(“message open knob” appears)
check power consumption (
±
1 kW). *
REPAIR INSTRUCTIONS