Philips FTL2.1E, Руководство по обслуживанию

Страница: 11 / 172

Mechanical Instructions EN 11 FTL2.1, FTL2.2E AA 4.
4.3.15 Ambient Lights
Figure 4-16 Ambient light
Ambient lights are located in the rear cover of the set.
1.
Remove all mounting Ambient lights screws (1) (some of
them are shown on the Figure above).
2. Remove the screw from the cable clamp (2).
3. Unplug the cables (3).
4. Shift the Ambient light unit to the side (4) and take out the
unit.
4.4 Assy/PWB Removal (for FTL2.2 “Wrap” Sets)
Note: Use figures from “Assy/PWB Removal (for FTL2.1 “Top”
Sets)“. Mind you that the different models can deviate slightly
from each other w.r.t. the mechanical construction. Where
necessary, you will find separate figures for clarification.
4.4.1 Metal Back Plate
Caution: Disconnect the AC Power (mains) cord before you
remove the metal back plate.
1. Place the TV set upside down on a table top, using the
foam bars (see part "Foam Bars").
Caution: do not put pressure on the display, but let the
monitor lean on the speakers or the Front cover.
2. Remove all T10 screws from the metal back plate.
3. Remove the four "mushrooms" (2) from the back plate.
4. Lift the back plate from the set. Make sure that wires and
flat foils are not damaged during the back plate removal.
4.4.2 Rear Cover
1. Remove all T10 parker screws (2) around the edges of the
rear cover.
2. Lift the rear cover from the set.
4.4.3 Main Supply Panel
1. Disconnect all cables from the Main Supply panel.
2. Remove all T10 mounting screws from the Main Supply
panel.
3. Take out the Main Supply panel.
4.4.4 Ambient Light Panel
1. Remove all mounting screws from the Ambient Light panel.
2. Disconnect all cables from the Ambient Light panel.
3. Take out the Ambient Light panel.
4.4.5 SCART3 Panel
1. Disconnect all cables from the SCART3 panel.
2. Remove the two mounting screws (7) near the SCART3 at
the connector plate (see figure "Connector plate").
3. Take out the SCART3 panel.
4.4.6 Stand-by Supply/Audio Panel
1. Disconnect all cables from the Stand-by Supply/Audio
panel.
2. Remove all T10 mounting screws from the Stand-by
Supply/Audio panel.
3. Take out the Stand-by Supply/Audio panel (it hinges at the
bottom side).
4.4.7 Side I/O Panel
1. Disconnect the cable(s) from the panel.
2. Remove the T10 mounting screws that hold the assy.
3. Release the clamps and take out the panel from its bracket.
4.4.8 Top/Side Control
1. Disconnect the cable(s) from the panel.
2. Remove the T10 mounting screws that hold the assy.
3. Release the clamps and take out the panel from its bracket.
4.4.9 LED Panel
1. Disconnect the cable(s) from the panel.
E_14620_052.eps
130504
4
4
2
3
1