Philips FTL2.1E, Руководство по обслуживанию

Страница: 9 / 172

Mechanical Instructions EN 9 FTL2.1, FTL2.2E AA 4.
4.3.4 Main Supply Panel
1. Remove all mounting screws from the Main Supply panel.
2. Disconnect all cables from the Main Supply panel.
3. Take out the Main Supply panel (it hinges at the right
(speaker) side).
4.3.5 SCART3 Panel
1. Disconnect all cables from the SCART3 panel.
2. Remove the two mounting screws (7) near the SCART3 at
the connector plate (see figure "Connector plate").
3. Take out the SCART3 panel.
4.3.6 Stand-by Supply / Audio Panel
1. Disconnect all cables from the Stand-by Supply / Audio
panel.
2. Remove all mounting screws from the Stand-by Supply /
Audio panel.
3. Take out the Stand-by Supply / Audio panel (it hinges at the
bottom side).
4.3.7 Side I/O Panel
Figure 4-7 Side I/O Panel
1. Disconnect the cable from the Side I/O panel.
2. Remove the mounting screws (1) if present.
3. Slide the Side I/O bracket to the right (2).
4. Release the clamp (3) and take out the Side I'O panel from
its bracket.
4.3.8 Top Control
1. Remove the mounting screws from the Top Control panel
bracket.
2. Disconnect the cable.
3. Release the clamps and take out the Top Control panel.
4.3.9 Proximity Panel
1. Remove the mounting screws.
2. Take out the Proximity panel and disconnect the cable.
4.3.10 LED / Switch Panel
1. Disconnect all cables from the LED / Switch panel.
2. Remove the mounting screws from the panel shielding and
remove it.
3. Remove the mounting screws from the LED/Switch panel.
4. Take out the LED/Switch panel.
4.3.11 Small Signal Board (SSB)
Figure 4-8 SSB top shielding
Figure 4-9 Connector plate
Figure 4-10 SSB
1. Remove the LVDS fixing tape (1).
2. Remove all fixing screws (2).
3. Lift the shielding at the top. The panel hinges at the SCART
side.
Caution: do not damage the EMC shielding foam while
you remove the shielding.
4. Remove mounting screws (3) from the connector plate.
Use a 5 mm socket screwdriver to remove both DVI
connector distance bolts (4).
5. Remove the mounting screws from the SSB (5).
6. Disconnect the LVDS cable (6).
7. Lift the SSB, disconnect all cables, and take out the SSB.
E_14620_029.eps
130504
3
2
1
E_14620_030.eps
130504
1
2
E_14620_031.eps
130504
7 3
4
E_14620_032.eps
130504
6
5