9.2 Change the Remote Control and receiver "Device" Settings
If you have other equipment in your home and the Philips remote control of your digital receiver interferes with them, you
can change the setting of your remote control and the setting of your receiver as well. By default, your receiver is
recognized as
Device 1
and the remote control is set to control
Device 1
. You may change this identifier to
Device 2
using
the
System Settings
screen from the
Settings
submenu. Please note however, that you will also have to change the
remote control setting in order to be able to control
Device 2
.
To change the setting of your remote control, proceed as follows:
1
Make sure that the remote control is in the STB mode (Press Mode button, the STB LED shall blink, if a different LED does,
press the Mode button as many time as necessary to get STB LED blinking).
2
Press number keys
1
and
3
simultaneously and hold them until LED blinks twice.
3
Release these two keys. The STB LED is still on to indicate that the remote control is in the programming mode.
4
Enter the new code setting within 60 seconds (the LED is blinking once after each digit entry): Either 0048 for Device 2 or
0038 for Device 1 (factory setting).
Alternatively you may reset your remote control to its default setting (Device 1) by removing and waiting for more than 3
minutes to insert batteries.
9.3 Master PIN Code
If you have forgotten your PIN code, you have the possibility to reset it to its default PIN code (1234). To reset the PIN
code, type in the so-called Master PIN Code (00799700). Type in the Master PIN code in quick succession on the level of
the
Main Menu
. Before you enter the Master PIN code, press the
m
m
key. Please keep this code secret to prevent your
children from using it.
26
ADVANCED SETTINGS
English
