Service Modes, Error Codes, and Fault Finding
5.
Figure 5-22 Example UART log during SWUPG startup (Normal startup) part 5.
•
The “Application selection startup” part in the logs shows
which application is being started up: backup SWUPG,
normal SWUPG, TV application, …
•
In the TV application (Normal startup) case, there is no
print on the UART which shows the software has started up
completely. When startup issues arise, the best way to
tackle them is by comparing the bad UART print with a
correct print of the same release.
Upgrade of a TV set.
Following cannot be seen during industrial mode!
•
When the Industrial Mode is enabled with command 203,
no prints can be seen anymore on the UART. This is to not
interfere with the P2P protocol.
•
When in normal mode, the UART will show what the
actions are during the upgrade.
•
At certain periods in time during programming, the total
size currently flashed (Totalsize flashed) and the size
which should be finally flashed (TotalProgramSize) will be
printed.
03 015.788 Census Found device uuid: c7a4be7e-547d-11dc-8034-cc1538aeec30
03 015.792 DeviceType: schemas-upnp-org:device:MediaServer:1
-1 016.098 AppMan: Window config - unhiding window
-1 016.098 Relayout of window 5
00 017.948 ***GVC: T2 - ceisusb_m.c (951): "usbdevspN_OnDeviceError( DeviceUnknownAttachedError, -1 )" notification given
00 018.154 ***GVC: T2 - ceisusb_m.c (951): "usbdevspN_OnDeviceError( DeviceUnknownAttachedError, -1 )" notification given
00 018.727 ***GVC: T2 - ceisusb_m.c (951): "usbdevspN_OnDeviceError( DeviceUnknownAttachedError, -1 )" notification given
00 024.079 --- pass 0 ---
00 024.082 freeMem : 26620
00 024.084 pgmajfault : 0
00 024.086 sectorsread: 11440
01 035.636 Merging eit data
01 035.650 Merging eit data
01 035.656 1419 records after eliminating duplicates
01 035.663 1419 records after eliminating duplicates
I_17662_004e.ep
s
11060
8