TROUBLESHOOTING
24
English
AZ 2536/01
page
24
Problem
Solution
CD/VCD OPERATION
"
NO DISC
" is displayed
–
Insert a disc.
–
Check if the disc is inserted upside down.
–
Wait until the moisture condensation at the lens has
cleared.
–
Replace or clean the disc, see "Maintenance"
Use a readable disc or correct recorded format
MP3-CD.
No picture on TV screen
–
Connect the cable between the system and TV.
No colour on TV
–
Change the system to the respective PAL or
NTSC setting.
RADIO RECEPTION
Radio reception is poor
–
If the signal is too weak, adjust the antenna
for better reception.
–
Increase the distance between the Receiver
and your TV or VCR.
TAPE OPERATION/RECORDING
Recording or playback cannot be made
–
Clean deck parts, see "Maintenance".
–
Use only NORMAL (IEC I) tape.
–
Apply a piece of adhesive tape over the missing
tab space.
GENERAL
The system does not react when buttons
–
Switch off the set. Remove and reconnect the
pressed/set does not work/no display on
AC power plug for 30 seconds and switch on
LCD.
the system again.
Sound cannot be heard or is of poor
–
Adjust the volume.
quality
–
Make sure the MP3-CD was recorded within
32-320 kbps (128kbps preferably) with sampling
frequencies at 8 - 48 kHz (44.1kHz preferably).
The remote control does not function
–
Reduce the distance between the remote control
properly
and the system.
–
Insert the batteries with their polarities (+/- signs)
aligned as indicated.
–
Replace the batteries.
–
Point the remote control in the direction of the
system's IR sensor.
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
AZ2536_01 eng 4/7/2004 05:51 PM Page 24
