DIGITAL TUNER
12
English
AZ 2536/01
page
12
Tuning to stations
1.
Press
STANDBY ON
y
to on, then press
SOURCE
once or more to select
FM/MW
.
=
Display: shows waveband, frequency, and preset station number if already stored.
2.
Tuning to stations
: you can tune to your stations manually or by
automatic search tuning:
Press down on
∞
or
§
(
5
or
6
on the remote control) and
release button when the frequency in the display starts running.
=
The radio automatically tunes to a station of sufficient
reception. Display shows
during automatic tuning.
3.
Repeat step 2 if necessary until you find the desired station.
•
To tune to a weak station, press
∞
or
§
(
5
or
6
on the remote control) briefly and repeatedly
until you have found optimal reception.
Changing tuning grid
(some versions only
)
In North and South America the frequency step between adjacent channels in the AM and FM band
are 10 KHz and 100 KHz respectively. In the rest of the world this step is 9 KHz and 50 KHz. Usually
the frequency step has been preset in the factory for your area if not
:
1.
Select
TUNER
source.
2.
Press
MODE
on the set for at least 6 seconds.
=
The display shows either
or
.
Helpful hints:
:
All preset stations will be lost and need to be reprogrammed.
To improve radio reception:
• For
FM
, extend, incline and turn the telescopic antenna. Reduce
its length if the signal is too strong.
• For
MW
, the set uses a built-in antenna. Direct this antenna by
turning the whole set.
RADIO RECEPTION
AZ2536_01 eng 4/7/2004 05:51 PM Page 12
