Mechanical Instructions
4.
5.
Remove both AL subframes (with the AL unit still mounted
on it) by unplugging the connector [2] and removing the
screws [3].
6.
Remove all remaining adhesive tapes and remove all
cables from their clamps.
7.
Carefully remove the conducting tape [4], it must be re-
used during re-assembly!
8.
Remove the remaining screws (indicated with an arrow)
that hold the plastic rim and remove the rim.
9.
Now the LCD Panel can be lifted from the front cabinet.
The panel has to be slided downwards
once it has been
lifted, because the brackets on the top cannot be removed
from the cabinet. You will see a conducting foam between
metal front and panel, near the location of the Piezo Touch
Control Panel.
When mounting a new LCD Panel:
1.
Check if this conducting foam between panel and metal
front is in place !
2.
Re-attach the conducting tape between LCD Panel and
metal rim [4] !
Figure 4-10 LCD Panel -1-
Figure 4-11 LCD Panel -2-
4.3.9
Wi-Fi antenna
Follow the instructions for
until “remove plastic rim”.
After removal of this rim, you gain access to the Wi-Fi
antennas.
4.4
Set Re-assembly
To re-assemble the whole set, execute all processes in reverse
order.
Notes:
•
While re-assembling, make sure that all cables are placed
and connected in their original position.
•
Pay special attention not to damage the EMC foams in the
set. Ensure that EMC foams are mounted correctly.
1
83
10_217_090
3
1
8
.ep
s
090
3
20
1
4
1
1
83
10_21
8
_090
3
1
8
.ep
s
090
3
19
3
2
