EN 40
Notes:
During installation, leave settings
unchanged unless your digital provider
gives you the specific values to enter.
When digital TV channels are found,
the list of installed channels may display
empty channel numbers. You can
rename, reorder or uninstall these
channels.
Install analogue channels
You can search and store analogue TV
channels manually.
Step 1: Select your system
Note:
Skip this step if your system settings
are correct.
1. While you watch TV, press .
2. Select
[Setup]
>
[Channel settings]
>
[Channel installation]
.
3. Select
[Analogue: Manual installation]
>
[System]
, then press
OK
.
4. Select the system for your country or
region, then press
OK
.
Step 2: Search and store new TV channels
1. In the
[Analogue: Manual installation]
menu, select
[Find channel]
, then press
OK
.
2. Select one of the following options:
Press the
Navigation buttons
or
Numeric buttons
to manually enter the
channel frequency.
Select
[Search]
then press
OK
to
search for the next channel
automatically.
3. When the correct channel frequency is
entered, select
[Done]
, then press
OK
.
4. Select
[Store as new channel]
, then press
OK
to store the new TV channel.
Install digital and satellite channels
Install digital channels
To improve TV reception, reposition the
antenna. You need to know the correct
frequency to tune. For best results, contact
the service provider or get a professional
installer.
1. Press .
2. Select
[Setup]
>
[Channel settings]
>
[Channel installation]
.
3. Select
[Digital: Reception test]
>
[Search]
, then press
OK
.
4. Press the
Numeric buttons
to enter the
channel frequency.
5. Select
[Search]
, then press
OK
.
6. When the correct channel is located,
select
[Store]
, then press
OK
.
7. Press
EXIT
to exit.
Notes
If the reception is poor, reposition your
antenna and repeat the procedure.
If you receive the channel with DVB-C,
select
[Automatic]
in
[Symbol rate
mode]
unless your cable provider
supplies you with a specific symbol rate
value.
Install satellite channels
Note
: Available on certain models only.
[Search for satellite]
is only available if the
TV supports DVB-S.
If your satellite receiver is connected to the
SAT connector, you can receive satellite
channels.
1. While you watch TV, press .
2. Select
[Setup]
>
[Search for satellite]
>
[Reinstall channels]
.
3. Follow the onscreen instructions to
complete the installation.
4. Once complete, select
[Finish]
, and then
press
OK
.
View satellite channels
To watch satellite channels, press >
[Watch satellite]
.