System Monitor PSM 2
REV 1A – Software V3
Page 6
5 Quick operation Start-Up of the PSM2
On the large illuminated colour touch
screen display, information of the
available systems is displayed and
operation and adjustments are possible.
If a device is connected to the network
and activated, details will be shown in
the appropriate sub menu.
In the headline, the following functions
from left to right
are available:
1) To activate the standby-mode the left switch must be touched upon. If you
want the PSM2 to return into operating mode you can touch the screen
anywhere.
2) The display is going to glow in the brightness which is adjusted for the
standby-mode in the Setup (Chapter 6.1.4). By touching the display one more
time it´s going to switch back into day-mode.
3) Display of Time
4) Display of the alarm list
5) Settings (Gear)
Before using the PSM2 System Monitor for the first time it is necessary to connect all
components to the PBUS network and ensure that they are all powered up. When this
is accomplished, the PSM2 System Monitor will recognise all the devices connected to
the network and will add them to its memory.
5.1 Password protection (PIN) of the Setup menu
The Setup menu is password protected.
When you choose “Setup” from the main
menu you will be asked for a PIN, which is
factory set to1234. Once the password is
entered and “OK” is pressed, the screen
will change to the Setup menu page.
NOTE: If the language on the main menu
appears to be German, press the button
“Einstellungen”, enter the PIN “1234” and
press OK. On the next screen press the
button “Anzeige”, then the button
“Sprache” and then you can choose the
language.
