System Monitor PSM 2
REV 1A – Software V3
Page 7
5.2 Identification of all devices connected to the PBUS
In the Setup menu, press “Display”, and on the next page press the arrow in the top
right-hand of the screen to go to page 2. On page 2, pressing “Connected Devices”
initiates a scan of all devices connected and shows them on the “Logged Devices” list.
If new devices are added they are logged on automatically. If changes are made to the
connected devices (e.g. new devices, devices omitted or not ready-to-operate) these
changes will be recognised automatically and only the connected devices will be listed.
ATTENTION: This function is only available on the PSM2 Monitor with the ID “0”.
If additional Displays are added, they must have different addresses; i.e. “1”, “2”,
etc.
If duplicate devices are listed after the device login, you to have to press the button
“Renew device addresses” in order to reset the sub-addresses of the connected and
active PBUS components.
5.3 Adjustment of the operational parameters
After identification of all devices you can adjust the individual parameters of the tanks,
batteries etc. Please have a look at the explanations of the parameters of each
component`s manual.
6 PSM Setup
All settings of the PSM2 display and the
devices connected to the network are
made in the Setup menu. Settings for the
connected devices are saved on the
devices themselves, and can be
accessed and adjusted from any PSM2
System Monitor on the network.
