EN - 10
12/2015
Copyright © 2015, Fast ČR, a. s.
5. Place a round container (e.g. tin can) on the individual sides (left, right, front, rear) of the top cover of the
washing machine. It the tin can is stable, the washing machine is level. If it rolls away, then it is necessary to
level the washing machine. The direction in which the tin can rolls indicates, where it is necessary to level
the washing machine. Then raise two feet at the same time until the washing machine is level. Repeat steps
1 - 3 until the bottom feet are touching the fl oor and the nuts are fi rmly tightened.
Connecting the water supply hose
Connect the supply hose as shown in the picture.
On models with a hot water supply connection, connect the hot water
hose to a hot water tap. Power consumption will be automatically
reduced for certain programs.
Installing the water supply hose
1. Connect the elbow to the tap and secure it in place by turning it
clockwise.
2.
Attach the other end of the hose to the inlet valve in the rear part
of the washing machine and fi rmly tighten by turning it clockwise.
NOTE:
If after connecting, you notice a water leak, repeat the above described procedure. The most common
type of tap is used for the water connection. If the tap is square or too large, it is necessary to replace it
with a standard tap.
Locating the drain hose
There exist two ways of locating the end of the drain hose:
1. Place it next to a water trough.
