Phihong USA Corporation
•
East Coast Engineering Center
•
630 Johnson Ave. Suite 102, Bohemia, NY 11716
•
Tel: (631) 610-2289
www.Phihong.com
4.4 GUI Port Description:
The Port Description panel shows 24-ports. On the PoE midspans that have 8 or
16-ports, the port number higher than the system port count will be shaded grey and disabled.
Each section specifies the individual port descriptions for the system.
Figure 17: Port Description
Changes to the port configuration in this section can be enacted when the user clicks the
“Send
Port Control”
button. It will send the port information to the µP for 24-ports
.
Please allow the
GUI 10 seconds to refresh when action is taken.
Port Description
– Click “Edit” to edit/change the description of the port. Click “Ok” to set
description on the GUI screen. If you click “Cancel”, the previous description will be set for that
particular port.
Click “Send Port Control” to send the descriptions to the system.
To make
this permanent, the user must click “Save Parameters to Flash.”
Enable
– This check box can administratively enable or disable the selected port.
If “Enable/Disable All Port” checkbox is selected, all ports will be enabled. Initially, the
checkbox is not checked, but by default all ports are enabled.
Click “Send Port Control” to
send the command to the system. To make this permanent, the user must click “Save
Parameters to Flash.”
If “
Detect Legacy Signature
” checkbox is selected, all ports are enabled and the firmware will try
to detect legacy devices. By default, legacy detection is disabled. The message in
blue
states that
the “
Legacy Detect is Enabled
” (Figure 16).
Click “Send Port Control” to send the command
to the system.
To make this permanent, the user must click “Save Parameters to Flash.”
or
www.Midspans.com
23
