13
Outer and chamber
1. Control panel <door front, upper>
The chamber temperature and other alarms/functions can be set through the keys on the control
panel. The running status can be checked by the temperature display and indicators [page 14 and
page 15].
2. Shelf support
These are used to support the shelves. Always set the shelves on the shelf supports firmly.
The shelves should be set with the stand edge backside.
3. Access port <refrigerator and freezer chamber>
These ports are used to pass the sensor or cable of measuring equipment, or sensor of automatic
temperature recorder (option) to the chamber.
Always replace the rubber caps and the insulation to the access port when no use or the rise of chamber
temperature or condensation outside the access port may be resulted.
4. Bottom shelf <1 for refrigerator, 2 for freezer>
To protect the storage items, always set the bottom shelf on the chamber bottom.
5. Space for temperature recorder
A temperature recorder (option) is mounted here and the chamber temperature can be recorded
automatically [page 44].
Contact our sales representative or agent for the installation.
6. Leveling foot <bottom, 4 locations>
This is the bolt for setting the product and adjusting the level on the right and the left. At the
installation, extend the bolt until the front casters are away from the floor to set the product.
7. Drain hose cap
This is used to drain the defrost water in the freezer chamber at the time of defrosting. The drain
hose is accessible by removing the drain hose cap [page 25].
Always replace the drain hose cap after draining.
8. Drain port
This port is used to drain the defrost water in the freezer chamber.
Always replace the port cap after draining.
9. Air exhaust vent
This is an air exhaust vent to circulating the air in the refrigerator chamber. Do not block this vent.
Blocking this vent may cause unstable chamber temperature.
Arrange the storage items not to be subjected to the cold air from this vent to avoid freezing.
10. Air intake vent
This is an air intake vent to circulating the air in the refrigerator chamber. Do not block this vent.
Blocking this vent may cause unstable chamber temperature.
Do not insert fingers or similar articles into this vent.
11. Back spacer (also used as a fixture)
This spacer keeps the space between the back and the back wall to keep the cooling performance.
Also, this spacer is used as a fixture. Fix the product firmly by using a rope or chain.
Switch area (upper left side)
Remove the cover when using the power switch or remote alarm terminal
After using, always replace the cover.
12. Power switch (also functions as a circuit breaker)
This is a power switch of the product. (ON; ”l” , OFF; ”O”)
13. Remote alarm terminal
A remote alarm device (marketed product) can be connected to this terminal. The alarm is noticed
to an operator in the remote area by the remote alarm when the product is installed in an unmanned
location.
Contact our sales representative or agent for the installation.
It is recommended to use cables with a maximum length of 30 meters.
