Phase AxN 70.140.4, Руководство по установке

Страница: 28 / 55

26
2.4.2 Motor Power Output Installation
Step 1: Find out the Motor Power Output Terminals
PE, A, B and C, these are the four terminals called Motor Power Output Terminals. AxN Size4 Drive
’s
Motor Power Output Terminals are in the Motor Power Output Port (P2) which is on the bottom
of the drive. Refer to the following figures for exact locations and terminal Assignment.
Step 2
：
Insert Wires into Corresponding Terminals
Use a 3mm hexagonal wrench to loosen the hexagonal screws on A, B, C and either of PE Terminals
which are i
n the drive’s Motor Power Output Port (P2). Insert the Wires of the motor power output
cable into the corresponding terminals: U to A, V to B, W to C and PE to PE.
WARNING: The correspondence between the Motor Power Output wires and terminals should
be adhered! Otherwise the motor cannot work properly!
NOTE: The metal part of the cord end terminal on the wire should be fully inserted into the
corresponding terminals. Leave only the insulated part outside.