3.4
DISPLAY
MODES
There are three measuring interface display modes: normal mode, A‐scan mode and B‐scan mode.
And there are three display modes of Normal interface: The thickness value mode, Difference/rate of
reduction measurement mode, MAX/MIN measurement mode. Select this in “VIEW MODE” of
configuration.
ATTENTION:
When the probe is properly “coupled” to the surface of the object being tested, the
display will be shown in WHITE. If not coupled properly then the values will be shown in GREEN. When
the values exceed the upper or lower limit setting then the values will be shown in RED.
THICKNESS
VALUE
MODE:
This interface mainly shows the velocity of material, the present thickness
value and unit.
3.4 NORMAL MODE INTERFACE
1—the
present
thickness
value
2—unit
3—material
velocity
4—battery
power
5—A—scan
interface
DIFFERENCE/RATE
‐
OF
‐
REDUCTION
MODE:
This interface shows the measured value, the preset
nominal thickness value, the difference between the measured value and the preset value and the ratio
between the difference and the normal value. Before using this mode, presetting the nominal thickness
is needed. The method can be taken according to chapter 3.6.
