Should pay attention to the following with infrared
detector installation:
1.Avoid the detector facing out of the window;
2.Within coverage of detection, there shall not be obstruction, such as shield, furniture, large
potted plants etc.
3.Avoid more than one detector in the same place, as they will possibly intervene with each
other by triggered simultaneously.
4.To avoid facing the window, cooling or warming machines, or other appliances that might
cause prompt temperature change and thus cause false alarm.
5.The detector needs about 3 minutes to perceive the surrounding environment after turn on,
then can arm or disarm by remote controller.
6.The detector needs several seconds to analyse and confirm when it detects the invasion
body, then release the alarm signals, thus can avoid false or missing alarm.
7.PIR detector is only for indoor use. ( Prohibit installing outdoors).
Installation and Use of Magnetic Door Sensor
Door sensor is installed on the door. First clean a right place of the door, take out the sensor
and then stick a double-sided adhesive at the bottom. Should pay attention to the following
when installing.
1.The transmitter(sensor body) and the magnetic bar should be installed separately, that is,
the body should be installed on the fixed frame and the magnetic bar should be installed on the
mobile door. (Notes: emitter indicator light nears the bar. ).
2.The magnet is installed apposite the transmitter, the distance between them should not be
more than 1 cm.
3.After installation, the indicator light flashes one second while opening the door which
means installation is available. Indicator light flashes 3 times which means the low power of the
battery, should replace the battery in time.
-7-
-8-
GSM anti-theft alarm controller
GSM anti-theft alarm controller
Please tear off the plastic insulating tape before use. Installation height is about 2.2 meters
from the ground, should be installed in a corner indoors to obtain the ideal detection range, at
the same time should be an angle with walking line indoors (The detection effect is best with
people’s walking direction into 90 - degree angle).
Installation method: Take out the bracket & base attached, insert the bracket into the slot of
the bottom of the PIR housing; fix the base firmly with two pieces of the screw, and insert the
bracket into the slot on the back of PIR detector and fix well.
Installation and Use of Infrared Detector
The recommended installation height
is 2.2m from the ground.
As
shown
below:
1.To determine the installation location
2.To fix the PIR detector
Fix the mounting bracket into the wall with
screws, and insert the bracket into the slot
on the back of PIR detector and fix well.
Ground
Please check whether the signal between door sensor
and alarm host is OK or not before fix the device; if
install on a metal door, to block up the bottom of
sensor to avoid shielding the signal; this product is
not suitable with the roller shutter, please buy the
special device if you need.
Notes:
Содержание CT-PG-100
Страница 2: ...GSM anti theft alarm controller...
