Important Information
Network Camera
Model No.
BL-C140
BL-C160
© 2008 Panasonic Communications Co., Ltd. All Rights Reserved.
PQQX16446ZA KK0508CM0 (CE)
How to Use the Documentation
This manual is written for both the BL-C140 and BL-C160. Available
features and operations vary slightly depending on the model. You can
confirm the model no. of your camera by checking the model no. printed on
the front of the camera.
Model number suffixes (“CE” and “E”) are omitted from the following model
numbers shown in this document, unless necessary. BL-C140CE, BL-
C140E, BL-C160CE, BL-C160E.
All documentation can be found on the included CD-ROM.
• Important Information
(PDF format; printed version also included)
This document. Provides general information and safety instructions for
using the camera.
• Installation Guide
(PDF format; printed version also included)
Describes how to physically connect the camera to the power supply
and network, as well how to mount or place the camera for regular use.
• Setup Guide
(PDF format; printed version also included)
Describes how to set up the camera so that it can be accessed using a
PC.
• Operating Instructions
(HTML format)
Explains how to operate, program, and maintain the camera.
• Troubleshooting Guide
(HTML format)
Provides solutions for problems you may have when using the camera.
Abbreviations
• The Network Camera is referred to as “the camera” in this document.
• The Setup CD-ROM is referred to as “the CD-ROM” in this document.
IMPORTANT SAFETY INSTRUCTIONS
When using this unit, basic safety precautions should always be followed
to reduce the risk of fire, electric shock, or personal injury.
1.
Read and understand all instructions.
2.
Keep these instructions.
3.
Heed all warnings.
4.
Follow all instructions.
5.
Attach the Safety Wire to the camera to prevent it from dropping.
6.
After taking away the sand or the dust on the lens cover, wipe the lens
cover with a dry cloth.
7.
Do not block any ventilation openings. Install in accordance with
instructions.
8.
Do not install near any heat sources such as radiators, heat registers,
stoves, or other devices (including amplifiers) that produce heat.
9.
Protect the AC adaptor cord and the AC cord from being walked on or
pinched particularly at plugs, convenience receptacles, and the point
where they exit from the unit.
10. The AC adaptor is used as the main disconnect device. Ensure that
the AC outlet is installed near the product and is easily accessible.
11. Only use attachments/accessories such as stand specified by the
manufacturer.
12. Do not touch the unit, the LAN cable, the AC adaptor, the AC adaptor
cord, or the AC cord during lightning storms.
13. Unplug the unit from power supply when unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing is required
when the unit has been damaged in any way, such as when the AC
adaptor, the AC adaptor cord, or the AC cord is damaged, the unit
does not operate normally, or has been dropped.
15. Prolonged exposure to direct sunlight or halogen light may damage
the image sensor.
16. Keep the sensor-range caps out of reach of children to prevent swallowing.
17. Unplug this unit from power outlets if it emits smoke, an abnormal
smell or makes unusual noise. These conditions can cause fire or
electric shock. Confirm that smoke has stopped and contact an
authorized service center.
18. The camera features a splash-resistant body, but it is not waterproof.
19. The AC adaptor, the AC adaptor cord, the AC cord, and the power
transfer unit are not splash resistant, and are intended for indoor use
only.
20. When connecting the cable, waterproof the cable using the included
right-angle joint, foam strip and self bonding tape.
21. When installing cables through the ground, do not connect cables
under the ground. Install cables through a conduit to protect them from
water.
22.
For BL-C160
CAUTION:
The camera of this unit utilizes LED lights.
Do not look directly at the LED lights for long periods of time, as this
can cause weakened eyesight.
SAVE THESE INSTRUCTIONS
Other Information
Environment:
Do not install the camera where the temperature is less than -20
°
C or
greater than +50
°
C. Allow 10 cm clearance around the unit for proper
ventilation. Avoid excessive smoke, dust, mechanical vibration, shock, or
direct sunlight.
Routine care:
Wipe the unit with a soft cloth. Do not use benzine, thinner, or any abrasive
powder.
When you leave the unit unused for a long period of time, disconnect the
plug of the AC cord from the outlet.
If you have any problems:
Consult an authorized service center.
CAUTION:
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this device.
System Requirements
Your PC and network must meet the following technical specifications in
order for the camera to function properly.
*1 What is IPv6?
• IPv6 is short for “Internet Protocol Version 6”.
• IPv6 was created to provide the additional IP addresses that will be
needed as the Internet continues to expand.
• IPv6 is expected to gradually replace IPv4, with the 2 coexisting for a
number of years during a transition period.
• Though most ISPs (Internet Service Providers) do not yet support IPv6,
many local networks already use it. When your ISP supports IPv6, your
Panasonic Network Camera will be ready!
• For more information, visit http://www.ipv6.org/.
Note:
Refer to the Panasonic Network Camera website at
http://panasonic.co.jp/pcc/products/en/netwkcam/
for details about network environment.
No responsibility will be taken by our company with respect to
consequences resulting from the use, damage or both of the
camera.
Item
Requirement
Operating System
For IPv4 Connection
Microsoft
®
Windows Vista
®
, Windows
®
XP,
Windows 2000
For IPv6 Connection
*1
Microsoft Windows Vista,
Windows XP Service Pack 1 or later
CPU
2.0 GHz Celeron
®
or faster
Display
1024 x 768 resolution or higher
Protocol
For IPv4 Connection
TCP/IP protocol (HTTP, TCP, UDP, IP, DNS, ARP, ICMP)
For IPv6 Connection
TCP/IP protocol (HTTP, TCP, UDP, IP, DNS, ICMPv6, NDP)
Interface
10/100 Mbps network card
Web Browser
Internet Explorer
®
6.0 or later (not included)
Additional Software
(For Viewing Buff-
ered MPEG-4
Images)
For Windows Vista
Windows Media
®
Player 11 or later
For Windows XP
Windows Media Player 9 or later
For Windows 2000
Windows Media Player 9
Please read this document before using the product, and save this document for future
reference.
Panasonic Network Camera Website:
http://panasonic.co.jp/pcc/products/en/netwkcam/regionlinks/index.html
Outdoor Ready
