PFS GB267, Инструкция по эксплуатации, Страница: 20 / 32

20 GB267 I01
7.4 Mounting the Rotational Peeling Tool
Attention!
For the Rotational Peeling Tool 25-63 mm an adjustment of the lower running shell is NOT
NECESSARY.
Step Action
1 Preparation of the Rotational Peeling Tool
1.1 To peel pipes on the lower end of the tool's dimension range (32 mm, 40 mm) it can be necessary,
(only for the Rotational Peeling Tool 20-125 mm) , to move the running shell with running
wheels (5) on the spindle because otherwise the peeler blade on the upper part of the tool might
not come into contact with the pipe surface. For adjustment loosen the cross handle (4).
After that move the running shell with wheels (5) to a position that is suitable for the pipe
dimension you want to peel. Use the counterbores when tightening the screw to be able to
securely hold the running shell in place. Rule of thumb: The smaller the pipe dimension, the more
you need to move the lower running shell upwards on the rail.
After that tighten the lower cross handle (4) again.
Note
The aluminium block with the blade holder (6) can only be moved so far down until it reaches the
end of the visible threaded rod.