14 1-800-732-2677
Charge the Receiver Collar
Do not charge your Receiver Collar every night. Frequent charging can have a negative effect on the
battery life. We recommend that the Receiver Collar be used until the Receiver Indicator Light blinks
red/green or red.
To Charge the Receiver Collar
1. Lift the rubber cover protecting the Receiver Charging Jack.
2. Connect the Receiver Collar Charger connector to the Receiver
Charging Jack. Note: The connector only fits one way, do not
force it into the charging jack.
3. Plug the Receiver Collar Charger into a standard AC wall outlet.
The Receiver Collar light will glow red when the charger is
properly seated and charging.
4. Charge the Receiver Collar for 2-3 hours. The light will turn
green when charging is complete. A built in safety circuit
prevents the Receiver Collar from overcharging.
5. After charging, replace the rubber cover to protect the
Receiving Charging Jack.
2A
The Receiver Collar must be fully charged prior to programming a Boundary. Each charge can last from
approximately 10 to 14 days depending upon frequency of use.
Prepare the Receiver Collar
To Turn On the Receiver Collar
Press and hold the Mode Button for 2 seconds (
3A
). The green light will light
up briefly and you will hear two tones chime (
3B
). When the Receiver Collar is
turned ON without a programmed boundary, the Receiver Collar will perform
the ReadyTest
®
sequence, two chimes and then shut down.
To Turn Off the Receiver Collar
Press and hold the Mode Button for 5 seconds (
3A
). The red Receiver
Indicator Light will be ON during this time. The red Receiver Indicator Light
will then turn OFF and all Receiver Indicator Lights will stay OFF indicating
that the unit is turned OFF. You will also hear a two tone chime indicating the
unit has been turned OFF. To extend the time between charging the Receiver
Collar, consider turning OFF the Receiver Collar when it is not in use.
ReadyTest
®
Feature
ReadyTest
®
gives you added confidence that the Receiver Collar is working
and ready to use. When you remove the Receiver Collar from the charger, the
receiver’s internal diagnostics will check that the battery charge is full and that
all circuits are working correctly.
3A
www.petsaf
e.net
www.pe
net
afe.n
etsa
ts
www.petsaf
e.net
w
w
w
w
w
w
w
p
p
p
p
p
e
e
e
e
e
t
t
t
t
s
s
s
a
a
a
a
f
f
f
e
e
e
e
n
e
e
3B
Step
2
Step
3
Содержание PAW POINT PIF00-13651
Страница 2: ...2 1 800 732 2677 ...
