Petsafe In-Ground Fence ZIG00-14654, Руководство по эксплуатации продукта

Страница: 13 / 32

12 +1 (800) 732-2677 petsafe.com 13
Transmitter Set-up
(Australia and New Zealand)
1. Run the Boundary Wire through a window, under a door, through a crawl space vent, or any other appropriate
available access. you can also drill a hole through your wall.
2. Strip
3
⁄
8
inch of insulation from the ends of the Boundary Wire.
3. Press the red tabs on the Fence Transmitter and insert the twisted wire into the Boundary Wire Terminals.
Make sure wires do not touch each other at the terminals.
4. Turn the Boundary Width Control Knob to 10. This will set the Boundary Width at the maximum width.
5. Plug Power Adapter into Power Jack and AC Power Outlet.
6. The Power Light and Loop Indicator Lights should come on. If this does not happen
see the “Troubleshooting” section.
• Do not install, connect, or remove your system during a lightning storm. If the storm is close
enough for you to hear thunder, it is close enough to create hazardous surges.
• Risk of electric shock. Use the Fence Transmitter indoors in dry location only.
If possible, DO NOT use an AC circuit protected with a Ground Fault Circuit Interrupter (GFCI) or
Residual Current Device (RCD). In rare cases, nearby lightning strikes may cause the GFCI or RCD to
trip. Without power your dog may be vulnerable to escape. You will have to reset the GFCI or RCD to
restore power to the system.
For added protection, when unused for long periods of time or prior to thunderstorms, unplug
from the wall outlet and disconnect the loop boundary wires. This will prevent damage to the
transmitter due to surges.