Perrot Water Control+ SC, Руководство по эксплуатации и обслуживанию, Страница: 19 / 34

e.doc Rev. 07.07.2015 Seite ‐ Page 49 / 64
Perrot REGNERBAU CALW GmbH Industriestraße 19 ‐ 29 / D ‐ 75382 Althengstett / Germany
Telefon : 0049 ‐ 7051 ‐ 162 ‐ 0 / Fax : 0049 ‐ 7051 ‐ 162–133
E ‐ mail: perrot@perrot.de / E ‐ mail Konstruktion : technik@perrot.de

Connect VP3 with Sector Scout as per wiring scheme on page 7.
Please note that in this case only 2 stations per module can be connected.
Change entries in the controller software as follows:
Channel A: wired with solenoid and
Channel B: wired with position sensor

Please proceed as follows:

Press and to select „Module setup“ and press to confirm.

Press and to select a station where a VP3 with Sector Scout is
supposed to be connected.

Use to set the selected station to „SC output“.
Warning
If both, stations with Sector Scout (VP3SC) and stations with valves
only, are connected to the same controller, all stations with Sector
Scout have to be connected in consecutive order starting from
module 1. The valves (no Sector Scout) can then be connected to the
remaining modules regardless of their order.

press to confirm entry.

To get back to the „Sector Scout“ menu, press „previous menu“.