PERODUA ALZA, Руководство пользователя

Страница: 451 / 508

14–5
Loosen
6. Loosen the oil filter with an oil filter wrench
and remove it by hand.
7. Apply new engine oil on the rubber gasket
of the new oil filter.
8. Tighten oil filter one turn after gasket
contacts mounting base.
Tightening torque:
12 - 16 N.m
(1.2 - 1.6 kgf-m)
9. Reinstall the drain plug and new gasket.
Tighten the drain plug.
Tightening torque:
23.6 - 35.4 N.m
(2.4 - 3.6 kgf-m)
CAUTIOR
Do not overtighten the oil filter and drain
plug. It could cause oil leakage.
10. Slowly pour engine oil.
For recommended engine oil and its
capacity, see Section 17.
11. Install the oil filler cap by hand.
12. Wait a few minutes and check the engine
oil level.
13. Run the engine and check if engine oil is
leaking from the oil filter or drain plug.
Any leak indicates improper installation
of the oil filter or drain plug.
14. Turn the engine off and wait a few minutes.
Check the engine oil level again and add
oil, if necessary.
WAARIRNG
w
• Clean any spilt oil. It may cause a
fire if it is left on a hot component.
• When checking or changing the
oil, be very careful not to allow the
oil to spill on the alternator etc. If
oil does spill on the alternator etc,
immediately wipe it off. Any spilt oil
is very dangerous, because it can
lead to fire in the vehicle.
• Wash your hands thoroughly.
• Prolonged contact with used
engine oil could cause skin cancer.
• Rever drain the used oil to the
ground, sewer, etc. Be sure to
dispose the used oil at a place
with adequate facilities. It is
recommended to change the oil
by an authorized Perodua Service
Centre.
• Securely install the oil filler cap. If
not, oil consumption may increase
and engine oil may be splashed on
the components, which may cause
a fire.
Sect 14 EN.indd 5 13/04/2018 12:19 PM