Permaquip Kubota RRV, Руководство пользователя

Страница: 39 / 56

MAN-M-O-190_13 09/10/2014 Page 39 of 56
The vehicle must be placed on straight, level, tangent track.

Apply spray paint to the flanges on treads of all Rail Wheels.

Lower and lock the Front and Rear Rail Gear.

Operate the vehicle for a short distance at a normal operating speed.
The paint should wear evenly around the flanges and treads of all Rail Wheels. If the
paint is worn evenly on all Rail Wheels, the vehicle and Rail Wheel equipment is
properly aligned.
If the paint did not wear evenly, note which Rail Wheels, flange and / or tread the
paint is worn on and:

Repaint the flanges and treads on all Rail Wheels.

Operate the vehicle in reverse for a short distance at a normal operating
speed.

Note which Rail Wheels, flange and/or tread the paint is worn on.
If the paint wore off on the right front flange when travelling forward and then on the
left rear flange when travelling in reverse, the vehicle is probably not aligned
properly.
Have the vehicle frame checked for proper alignment.
9.15. Resetting the CCTV Camera
If the CCTV monitor is always on, regardless of road / rail mode or ignition on / off,
the auxiliary battery has been left to go flat (thereby allowing the CCTV system to go
back to factory default mode and not to Rail mode, standby). To reset the CCTV the
following procedure needs to be undertaken:
1. Recharge the battery with a suitable charger.
2. Turn off the vehicle ignition.
3. Undo the 8 panel screws on the control module, ensuring that the panel does
not fall out.
4. Unscrew the 4 nuts on the monitor support
– ensure that the pillars do not
rotate.
5. Remove the monitor off the pillars.
6.
Press the ‘Power’ button (located on the front, top right). This will reset the
monitor to ‘standby’ shown by the red LED.
7. Reassemble in reverse order, taking care not to allow the monitor support
pillars to rotate or to trap any wires.
8. The monitor will now operate correctly, only working in Rail mode.