Illustration 9
g03011037
2.
Ensure that fuel filter base (3) is clean and free
from damage. If necessary, replace the complete
fuel filter base and filter assembly.
3.
Position fuel filter base (3) on the mounting
bracket. Install nuts (6). Tighten the bolts to a
torque of 25 N·m (221 lb in).
4.
If necessary, install a new fuel filter (7) to canister
(8). Install cannister (8) to fuel filter base (3). Refer
to Operation and Maintenance Manual, “Fuel
System Secondary Filter - Replace” for the correct
procedure.
Illustration 10
g03011036
5.
Remove the plugs from the plastic tube
assemblies. Remove the caps from the ports in the
fuel filter base.
NOTICE
Ensure that the plastic tube assemblies are installed
in the original positions. Failure to connect the plastic
tube assemblies to the correct ports will allow contam-
ination to enter the fuel system. Allowing contamina-
tion to enter the fuel system will cause serious
damage to the engine.
6.
Connect plastic tube assembly (1) and plastic tube
assembly (2) to the fuel filter base.
7.
Connect harness assembly (5) to fuel temperature
sensor (4). Slide locking tab in to the lock position.
8.
Turn the fuel supply to the ON position.
9.
Turn the battery disconnect switch to the ON
position.
End By:
a.
Remove the air from the fuel system. Refer to
Operation and Maintenance Manual, “Fuel System
- Prime” for the correct procedure.
UENR4503
11
Disassembly and Assembly Section
