Illustration 5
g03011036
4.
Make temporary identification marks on plastic
tube assembly (1) and plastic tube assembly (2) in
order to show the correct position of the plastic
tube assemblies.
5.
Place a suitable container below the fuel filter base
in order to catch any fuel that might be spilled.
6.
Disconnect plastic tube assembly (1) and plastic
tube assembly (2) from fuel filter base (3).
7.
Use Tooling (A) in order to plug plastic tube
assembly (1) and plastic tube assembly (2)
8.
Use Tooling (A) in order to cap the connection on
fuel filter base (3).
9.
Slide locking tab in to the unlock position.
Disconnect harness assembly (5) from fuel
temperature sensor (4).
Illustration 6
g03011037
10.
Remove cannister (8) from fuel filter base (3).
Remove secondary filter (7). Refer to Operation
and Maintenance Manual, “Fuel System
Secondary Filter - Replace” for the correct
procedure.
11.
Remove nuts (6) from fuel filter base (3). Remove
the fuel filter base from the mounting bracket.
Note:
Do not disassemble the fuel filter base.
UENR4503
9
Disassembly and Assembly Section
