PerkinElmer SPECTRUM TWO N, Руководство пользователя

Страница: 84 / 125

84 . Spectrum Two N User's Guide
Power Save Mode
There are two ways you can put the instrument into a low-power mode: by pressing the
power button on the front of the instrument or using the Power Save option in Spectrum
software.
NOTE: If the power to the instrument is suddenly cut off, for example by disconnecting the
power supply, then you must connect the instrument to Spectrum software once the
power supply is re-established to apply any Power Save mode settings.
Using the button on the front of the instrument
To put the instrument in low-power mode:

Press the Power On button on the front of the instrument (Figure 72) for approximately
2 seconds until the LED turns from solid green to solid yellow.
If you are connected to the instrument in Spectrum software, the Setup Instrument tabs
Measurement menu and the Scan toolbars will be disabled.
Figure 74 Power button on the instrument
NOTE: If you use the Power button to put the instrument in low-power mode, the
instrument will not be under software control. Consequently, any scheduled Power
Save mode event in Spectrum software will not occur until after you have manually
repowered the instrument.
To power up the instrument again:

Press the Power button on the front of the instrument for approximately 2 seconds until
the LED turns green.
The instrument will take a couple of minutes to initialize. When the initialization is
complete, and if you were connected to the instrument previously, the Setup
Instrument tabs and Scan toolbars will be available.