Trouble Shooting:
1)
The motor doesn’t go on:
a)
Turn the switch to the off position and press the circuit breaker reset
button located on the back of the motor base.
b)
Make sure the outlet has power to it and check to see that plug is securely
in wall outlet.
c) Make sure you are turning the switch to the “forward” position.
2)
I can’t unscrew the locking ring:
a)
To loosen it, make sure you are turning the locking ring in a clockwise
direction while facing the pulp outlet.
b)
Turn the machine back on and let it run for 1-2 minutes until all or most
the pulp has been pushed through. Then shut machine and try to unscrew
locking ring using wrench.
c)
Try repositioning wrench at 90 degrees for more leverage and try not to
over tighten locking ring next time.
3)
There is pulp in my juice:
Pour the juice through a small fine-mesh stainless steel strainer to remove the
pulp (not included).
Technical Data:
Power supply:
110V / 60Hz
Motor Power:
375 W / 0.5 HP
Power input idling:
242 W
Power input under load: 615 W
Rated speed of motor: 1661 rpm
Rated speed of auger:
75 rpm
Insulation class:
B
Weight:
33 lb
6
