INSTALLATION INSTRUCTIONS
(Continued)
19
Anchor the Outdoor Unit
The outdoor unit can be anchored multiple ways* — a pad on the ground, a wall bracket, or a stand/blocks
(*not included).
Installing the unit on a concrete condenser pad:
1. Mark the positions of the four feet.
2. Pre-drill holes for expansion bolts, clean any dust away from holes.
3. Place a nut on the end of each expansion bolt.
4. Hammer expansion bolts into the pre-drilled holes.
5. Remove the nuts from expansion bolts. Place outdoor unit on bolts.
6. Put washer on each expansion bolt, then replace the nuts.
7. Using a wrench, tighten the nuts until snug.
Installing the unit on a wall-mounted bracket?
Please refer to the bracket manufacturer’s directions for installation.
STEP 6. SECURING THE OUTDOOR UNIT
WHEN DRILLING INTO CONCRETE, EYE PROTECTION IS HIGHLY RECOMMENDED.
WARNING
