INSTALLATION INSTRUCTIONS
(Continued)
15
STEP 1. MARKING THE WALL (USING TEMPLATE)
The mounting bracket is the device on which you will mount the indoor unit, it is the silver bracket on the
back of the indoor unit. A mounting template has been provided to assist you with proper hole and indoor
unit placement to assist you with the proper location of the holes for the indoor unit mounting bracket and the
power cable / condensate drain pipe.
In the location chosen during pre-planning, locate studs in the wall using a stud finder. If you cannot find a
stud, you will need to use wall anchors.
1. Place the mounting plate template against the wall, in a location:
• On an exterior wall, at least 6 inches (15.25 cm) from the ceiling and 4.75 inches (12 cm) from adjacent
wall (refer to Figure 1.1).
• Where two studs can be drilled directly into to support the mounting bracket.
• Where the line set hole, as marked on the template, will be free of electrical wiring, plumbing, and other
sensitive components that may be hidden in the wall.
2. Use a level to make sure your template is level.
3. Using something sharp like a nail, mark the areas of the wall where you will be drilling your screws and
the line set hole.
4. Remove the mounting template from the wall.
6 in. (15.25 cm)
4.75 in. (12 cm)
Figure 1.1
NOTE:
We strongly advise using the hole located on the right side of the template, as this is where the
indoor unit will have the line set bundle located. If you choose to move the bundle to the left side of the
unit, then you will need to make your line set connections inside, before mounting the unit.
