Installation and Operation Manual
for
Perenio®
UV Lamp
Doc Version: 1.0.2
©Perenio IoT spol s r.o. A
ll Rights Reserved
Page
18
из
39
ATTENTION!
Failure to remove dust, dirt and fingerprints from the glass surface
of the UV tube before operation may shorten its life.
6.
Hold the bases with hands and insert the UV tube into the lamp bracket so that
the base connectors are completely inserted into holes in the lamp bracket.
Then, rotate the UV tube in the lamp bracket so that the connectors are not
visible in the holes.
Do not touch the glass with your hands!
7.
Connect the power cord to the UV lamp (
Do not connect the device to the
power source
).
8.
Close all windows tightly, turn off the air conditioner and/or block air ducts at
the treatment site.
9.
Select the way to control the UV lamp as follows:
•
Remote control via the
Perenio Smart/Perenio Lite
mobile app using
the Power Link smart plug, or through voice assistants;
•
Manual control.
The UV lamp is deemed to be installed and ready for use.
2.2 General UV Treatment Rules
ATTENTION!
Please read
“
Warnings
and Restrictions”
Section of this document
carefully before turning on the device.
The most effective way is to use the UV lamp in rooms without air circulation at a
temperature from +24°C to +26°C.
Please note that people, animals and plants are not allowed in the room during UV
treatment, as well as immediately after the process is finished, since ultraviolet
radiation and accumulated ozone may have a negative effect on their health and lead
to respiratory damages.
