Assembly and Operation Manual
The duration of waiting period for “
Direction open
” mode is defined by the duration of control signal
on the contact related to opening direction of the swing panel.
9.4 Emergency situations
In case of fire, disasters and any other emergency situations it is necessary to provide emergency
exit to evacuate people. For example,
BH-02
anti-panic rotary sections can be used as an
emergency exit.
The passageway of the swing gate can be used as an additional emergency exit. The construction
of the gate allows providing exit without use of any special keys or tools. Apply
Fire Alarm
control
signal to the control board. The swing panel will open automatically making the passage free
regardless of the set operating mode. Other control commands will be ignored. The opening
direction is defined by
FireAlarmDir
jumper on the control board. When the signal is turned off, the
swing panel moves to
“Closed”
position and locks.
Device sending
Fire Alarm
emergency unlocking signal is not included into standard delivery set.
Besides, the swing gate is basically a normally open device, meaning that in case of power failure
the swing panel can rotate manually ±90º, making the passage free.
9.5 Troubleshooting
Possible faults to be corrected by the user themselves are listed in Table 6. In an unlikely event of
other faults please consult the
PERCo
Technical Support Department.
Table 6. Troubleshooting
Fault
Possible cause
Remedy
When powered-up,
RC-panel indication
does not work
No supply voltage on
control board
De-energize power supply unit. Remove the cover
and housing of the gate. Check the power cable
and its connection to the
XT1
terminal block.
The gate cannot
operate in one of the
directions, RC-panel
indication is on
Control signal of
chosen direction is
not applied to the
control board
De-energize power supply unit. Remove the cover
and housing of the gate. Check the cable of RC
panel / WRC device / ACS controller and its
connection to the
XT2
terminal block
10
TRANSPORTATION AND STORAGE
The swing gate in the original package should be transported only in closed freight containers or
other closed type cargo transport units.
During storage and transportation boxes with swing gate posts can be stacked no more than 2
layers high. Stacking of boxes with glass panels is not allowed.
The swing gate should be stored in dry indoor facilities at ambient temperatures from –40°C to
+50°C and at relative air humidity of up to 98% at +25°
С
.
After transportation or storage at below-zero temperatures or high air humidity, the swing gate
should be kept unpacked for minimum 24 hours under normal climate conditions corresponding to
operation conditions.
11
MAINTENANCE
Technical maintenance of the swing gate should be performed only at
PERCo
service center.
We recommend using liquid non-abrasive cleansers containing ammonia to clean a swing gate
post and a glass panel when dirty.
18
