PERCo RTD-03S, Руководство по эксплуатации

Страница: 6 / 26

RTD-03S Waist-high rotor turnstile
5
•
The barrier wing rotation sensors are built in the turnstile post base and ensure accurate
count inputs to the ACS.
• There are two variants of the turnstile control from the ACS – pulse and potential.
• The external turnstile components, except for filler panels, are made of polished stainless
steel.
• The filler panels are made of prestressed glass or polycarbonate plastic.
5.2 Design
The turnstile overall dimensions are given in Fig. 1. The design of the turnstile is shown in Fig. 2.
Numbers in brackets correspond to Fig. 2.
The turnstile consists of the turnstile post with barrier wings, the control unit (8) and the remote
control panel (9), connected to the turnstile post with the power cable (11) and the control cable
(10) via the cable connectors block (16).
The turnstile post is supplied assembled and consists of the post with flange (2) and the rotary post
(1). Four barrier wings (6) are mounted on the rotary post (1). The filler panels (7) are set into the
barrier wings (6) with the fastenings (15). On the rotary post (1) cover (3) there is the mechanical
release lock (4).
The turnstile post with flange (2) is fastened to the floor with the M10x70 screws with recessed
hexahedron.
In the turnstile post with flange (2) there are the electric drive, the locking devices, the optic barrier
wing rotation sensors, the bearing units, the power module and the cable connectors block (16).
To form the passageway it is possible to use several variants of guide barriers set (see Appendix).
The remote control panel (RC) (9) is designed in the form of a small desktop device with a
shockproof ABS plastic case and is intended for setting and indication of the operating modes
when the turnstile is operated manually. The remote control panel (9) is connected to the
processor module inside the control unit (8) with a multi-thread floppy tape (13) via a cable inlet on
the lower panel of the control unit (Fig. 3 and Fig. 9).
Figure 1. Dimensions of the RTD-03S waist-high rotor turnstile