PERCo RTD-03S, Руководство по эксплуатации, Страница: 15 / 26

Operation manual
14
connectors block (16) into the turnstile post with flange (2) at height suitable for further
installation. Place the turnstile post in the upright position.
6. Mount the turnstile post flange on the anchor bolts sleeves. The turnstile post should be
mounted strictly upright. The turnstile post adjustment is recommended to perform by installing
the different-size gaskets under the turnstile post flange. Note, the turnstile post is heavy, hold
it to prevent the fall. Fasten the turnstile post with three screws M10×70 with recessed
hexahedron.
7. Take the barrier wings (6) out of the shipping box. Set the filler panels (7) into the fastenings
(15), aligning them in height and observing gap uniformity, and fix them with the fastenings
screws. Mount the barrier wings into the coupling fittings (14) of the rotary post (1). Tighten the
barrier wings (6) mounting screws through the coupling fittings (14) holes. Check the strong
fastening of the barrier wings (6) and the filler panels (7).
8. Check free rotation of the rotary post (1). Unblock the rotary post with the mechanical release
key (5) (see Clause 5.5). The rotary post (1) with barrier wings (6) should be turned by hand
easily without jamming. The rotation force at the center of the barrier wing (6) should be not
more than 1.5 kgf. The rotation force can be measured by a dynamometer or a domestic
spring balance. Block the turnstile with the key (5) after the check.
9. Mark out the holes for wall mounting of the control unit (8) as shown in Fig. 8. Drill the holes
and insert the plastic dowels, included in the installation kit. Insert the top screws, suspend the
control unit and fix it with the bottom screw to prevent the accidental pull off. Fix the control
unit (8) considering that the convenient access to the toggle switches, fuses and indicators is
provided (Fig. 3). The control unit (8) should be mounted on the wall upright with the
connectors down. The AC power cable (12) should easily touch the mains plug.
Figure 8. Hole pattern for CU mounting