PERCo RTD-03S, Руководство по эксплуатации, Страница: 18 / 26

RTD-03S Waist-high rotor turnstile
17
9.2 Operating modes
After its power-up the reset state of the turnstile is the “Closed” position (the mechanical lock is
locked up with a key).
The following operating modes with the corresponding indication, which can be set from the RC,
are shown in Table 1.
Features:
•
Installation of any type mode by pressing the buttons on the remote control (or a wireless
remote control) in an appropriate combination;
•
pressing STOP turnstile switches to "Closed", and the automatically reset the barrier wing to
the reset state;
•
In the “Single passage” mode (in the chosen or both directions) the locking device,
corresponding to the chosen direction, is unblocked. The turnstile remains in the “Open
position” for a time period, which is called the passage waiting time and is 5 sec. preset;
•
For passage one should turn the barrier wing at 15° in the passage direction. The electric drive
will automatically reset the barrier wing to the reset state in the passage direction;
• In the “Single passage” mode if the passage is not effected within the passage waiting time,
the turnstile will close automatically and the “Always locked” mode will be set ;
• At setting the “Single passage mode” in one direction and then in the other direction, the
countdown of the passage waiting time is effected for each direction independently;
•
In the “Bidirectional single passage” after the passage is effected in one of the directions, the
electric drive will automatically reset the barrier wing to the reset state. The turnstile is ready
for passage in the other direction and the passage waiting time is counted for the other
direction afresh at that;
•
In the “Single passage” mode at completing the barrier wing rotation cycle to the reset state,
the other mode setting, except for the “Always locked” mode, will be blocked. A command for
the new passage mode, entered by the RC, will be enquired in the command queue of the
turnstile;
• After the barrier wing is reset to the reset state, the command from the command queue will be
performed automatically;
•
In the “Always free” mode (in the chosen or both directions) the electric drive will automatically
reset the barrier wing to the reset state, like in the “Single passage” mode. The passage
waiting time is not counted at that;
•
It is possible to change the “Free passage in the set direction” to the “Free passage in the set
direction and single passage in the opposite direction” mode. In the “Free passage in the set
direction” mode push the button, corresponding to the other passage direction, on the RC (or
the tag of the wireless remote control kit). After the passage is effected, the turnstile turns to
the previous mode;
•
At completing the barrier wing rotation cycle, if forced blocking of the barrier wings is applied,
the turnstile stops rotation during 3 sec and then resets the barrier wings in the same direction;
•
If forced blocking of the barrier wings is applied for the second time, the turnstile turns to the
emergency mode with intermittent indication on the RC and an intermittent audio signal. The
emergency mode duration is 10 sec, after that the electric drive resets the barrier wings to the
reset state;
• If the turnstile is set in the “Single passage” mode (in the chosen or both directions), it turns to
the “Always locked” mode after the emergency mode;
•
To cancel the emergency mode, push the STOP button on the RC (or the tag of the wireless
remote control kit);
•
If the turnstile is set in the “Free passage” mode (in the chosen or both directions), it turns to
the earlier preset mode after the emergency mode.
Note 1:
If it is necessary to free the passageway for more than one hour, turn off the power and
unlock the turnstile with the key override in order to avoid overheating of the magnet winding
(ref. sect. 5.5).
Note 2:
Proceed as follows to change the RC orientation towards the turnstile post: