PERCo RTD-03S, Руководство по эксплуатации

Страница: 19 / 26

Operation manual
18
•
Set the «Power» and «Battery» switchers on the control unit (8) in the «0» position (Fig. 3);
• Disconnect the power cable (12) from the mains;
•
Swap positions of the following RC cables inside the control unit, on the connectors X3
and X4 of the processor module (Fig. 9) white with green and yellow with red cable, that is
connect the cables as follows:
a) white— to contact 3 on the X3;
b) green – to contact 1 on the X3;
c) yellow – to contact 3 on the X4;
d) red — to contact 1 on the X4;
• check all the cable connections are correct;
•
turn the power on as per section 9.1;
•
check the operation as per section 9.2.
Table 2. Turnstile operating mode
№ Turnstile operating
mode
Your actions
Indication on
the RC
Indication
outputs
status
Turnstile status
1
Always locked (Closed
for entry and exit)
Press the STOP
button on the RC
The red
indicator above
the STOP button
is on
“LED Red_L”
and “LED
Red_R”
outputs are
active
The barrier wings
are in the reset
state. The barrier
wings rotation is
blocked in either
direction
2
Single passage in the
set direction (open for
passage of one person
in the chosen direction)
Press the button
corresponding to
the chosen
passage direction
The green
indicator above
the button of the
chosen passage
direction and the
red indicator
above the STOP
button are on
“LED Grn_L”
or
“LED Grn_R”
output is active
depending on
the set
direction
The barrier wings
rotation in the set
direction is allowed
3
Bidirectional single
passage (open for one-
by-one person passage
in each direction)
Press both
passage buttons
simultaneously
(left and right side
buttons on the
RC)
The two green
indicators (left
and right) and
the red indicator
above the STOP
button are on
“LED Grn_L”
and
“LED Grn_R”
outputs are
active
The barrier wings
rotation in one
direction and then
in the other
direction is allowed
4
Free passage in the set
direction (open for free
passage in the chosen
direction)
Press the
STOP
button and the
button
corresponding to
the chosen
passage direction
simultaneously
The green
indicator above
the button of the
chosen passage
direction is on
“LED Grn_L”
or
“LED Grn_R”
output is active
depending on
the set
direction
The barrier wings
rotation in the set
direction is allowed
without any
limitations
5
Free passage in the set
direction and single
passage in the
opposite direction
(open for free passage
in the chosen direction
and for a person’s
passage in the
opposite direction)
Carry out actions
stated in Chapters
2 and 4 of the
present table in
any order
The two green
indicators above
either passage
direction and the
red indicator
above the STOP
button are on
“LED Grn_L”
and
“LED Grn_R”
outputs are
active
The barrier wings
rotation on the free
passage direction
without any
limitations and a
single rotation in
the opposite
direction are
allowed