PERCo CL-05.2, Руководство по эксплуатации, Страница: 10 / 42

CL-05.2 Lock Controller
5.5 Choosing IP-address setting method
Controller IP-address setting method is chosen by jumper installation and removal on
XP1
output on the controller back side. Output configuration is given on Fig. 1.
Attention!
Jumper installation and removal should be performed on de-energized equipment
only.
There are the following IP-address setting methods:
1. User mode. Jumper removed.

If the IP-address (gateway, subnet mask) has not been changed by the user, the
controller will operate with the initial settings: IP-address and MAC-address are
stated in the controller certificate on the controller board; subnet mask 255.0.0.0;
gateway IP-address 0.0.0.0.

If the IP-address (gateway, subnet mask) has been changed, the controller starts to
operate with the new settings immediately.
Note:
Controller network settings change is possible only from the PC through the Web-
interface or from the Software. At that the controller and the PC are to be in one
subnet.
2.
“IP-MODE”.
1–2 jumper position.

This mode is aimed at operation in networks with IP-address dynamic allocation. At
that the controller gets the IP-address (gateway, subnet mask) from DHCP-network
server/
3.
“IP-DEFAULT”.
2–3 jumper position.

The controller operates with initial settings. IP-address and MAC-address are stated
in the Controller certificate and on the controller board; subnet mask 255.0.0.0;
gateway IP-address 0.0.0.0.

Controller access password is cleared.
Note:
User settings of the IP-address (gateway, subnet mask), in case they have been
set, are saved when switching to
“IP DEFAULT”
mode. With next powering, if the
jumper is removed, controller will start operating with these settings.
Table 2. Possible variants of jumper installation on
XP1
output
№ Jumper position on
XP1
Mode
1 User mode
2 “IP-MODE”
3 “IP-DEFAULT”
9