WHA-GW-*
Commissioning
22
1981
2011
-0
7
42
Parameter window of Ethernet communication DTM
6. Set the parameters according to your preferences. In most cases, the default values
should be fine.
7. In some cases you might have to edit the
Additional Functions > Set DTM addresses
menu. Please read the following instructions for further information.
8. Click
OK
to save the changes and to close the parameter window.
Editing
Additional Functions > Set DTM addresses
of the
HART IP
Communication
DTM
The
Additional Functions > Set DTM addresses
menu contains settings which are
important for establishing a connection between the communication DTM and the
Gateway. The IP address, bus address and UDP port set in this menu must match the
corresponding parameters set in the gateway. When using a new Gateway, there is no
need to change the following parameters, because the default settings of the gateway
match the default settings of the HART IP Communication DTM.
1. Right-click on the entry
HART IP Communication
.
Ethernet communication DTM in PACTware project
A context menu is displayed.
2. Choose
Additional Functions > Set DTM addresses
.
The
Set DTM addresses
window is displayed.
HART IP Communication > Additional Functions > Set DTM addresses
3. Change the parameters as required (see following table).
4. Press
Update changed data
to apply the new settings.
5. Disconnect and reconnect the communication and the Gateway DTM to activate the
new settings.
