Pepperl+Fuchs FD0-VC-Ex4.FF, Руководство пользователя

Страница: 42 / 60

Fieldbus Valve Coupler FD0-VC-Ex4.FF
Error detection and problem solutions
42
Subject to reasonable modifications due to technical advances. Copyright Fuchs, Printed in Germany
Fuchs Group • Tel.: G49 621 776-0 • USA +1 330 4253555 • Sin65 67799091 • Internet http://www.pepperl-fuchs.com
P
a
rt
N
o
.:
1
082
27
, D
a
te
o
f i
ssue
27
.0
3.2
006
Status values of process parameters
Miscellaneous
Valve Lead Fault Short Circuit Valve Lead short circuit at
valve lead. Check wiring.
Lead Breakage Valve Lead interruption at
valve lead. Check wiring.
Sensor Lead Fault Short Circuit Sensor A/B Lead short circuit at lead
to PFC A/B. Check wiring.
Lead Breakage Sensor A/B Lead interruption at lead
to PFC A/B.
Check wiring.
Status messages Cause Elimination Cross reference
Bad - Out of Service Mode of block is "Out of
Service" Specify target mode "AUTO". See section 6.5.5 and
"Diagnosis messages".
Bad - Device Failure Hardware error Send device to
Fuchs for repair.
Bad - Sensor Failure,
Low limited Lead interruption sensor Determine the affected sen-
sor in the device from the
"Sensor Lead Fault" parame-
ter.
See " lead error sen-
sor".
Bad - Sensor Failure,
High limited Lead short circuit sen-
sor Determine the affected sen-
sor in the device from the
"Sensor Lead Fault" parame-
ter. See " lead error sen-
sor".
Bad - Sensor Failure "Position detection fail-
ure"; the signal combi-
nation of the PFCs is
not assigned to a valve
position • Check parameterisation of
"Sensor Usage".
• Check PFCs for proper
functioning.
See "diagnosis mes-
sages" and section
6.5.4.
Bad - Non Specific This value is not used
due to the current
parameterisation Check parameterisation of
"Sensor Usage". See section 6.5.4.
Problem Cause Elimination
Cross
reference
The transducer
block does not
leave the "Out of
Service" mode There is a block configuration
error which is signalled in
"BLOCK_ERR" Parameterise the "Actuator Fail
Action", by entering the drive mode
"self-closing" or "self-opening". See section
6.5.3 and 7.3
„BLOCK_ERR“.
The resource block is in "Out of
Service" mode Set resource block into "AUTO"
mode. See also sec-
tion 7.2.
Auxiliary valve
not controlled The reference value specified
by the DO function block has
the status "bad" or "uncertain" Check reference value, correct, if
necessary. See section
6.6.1.
Transducer block is in "Out of
Service" mode Set transducer block into "AUTO"
mode. See also sec-
tion 7.3.
Hardware or lead error Check diagnosis messages. See also sec-
tion 7.3.
Simulation is switched ON in
function block Switch OFF simulation. See section
5.4.2 and
Appendix B.
Problem Elimination of error
Parameter Message Cause Elimination