Page | 8
Display Does Not Boot-Continued
iii.
Test the PMG Aux cable blue barrel pins shown below, with
1. Pins 2 and 7 should read 12 volts +/- 0.5 and
2. Pin 8 should read less than 10 ohms to a known-good source
iv.
If the Ignition/Ground pins lack power or ground, try an alternate PMG
1.
If that works, RMA the original PMG as “No Power”
2. If that does not work, replace the PMG Auxiliary Cable
v.
If the Ignition/Ground pins do check out, visually inspect the cradle cable for damage, particularly near wear
points. Replace the cable if needed.
