05
Filtration control:
- By calculating the time according to the pool temperature (automatic mode).
- By programming a 24 hour cycle (makes it possible to benefit from off hours).
- By integrating the frost protection function (activation of the filtration below 3°C)
- By giving priority to the heating, RedOx regulation, or pH (if the value of one of these references falls below
the set value, the filtration will start on the next hour, on the hour).
- Possibility to select the start time and end time of the filtration in automatic mode (to prevent noise at night).
- Possibility to increase or reduce the filtration time according to the use of the swimming pool (economical
mode = pool with a low number of visitors, turbo mode = pool with a high number of visitors).
- Possibility to change into “SHOCK” mode (forcing of the filtration and electrolyser for 24 hours) via the
supplied remote control or in the filtration menu.
- Automatic warning of the need to backwash the filter.
- Automatic detection of performance of filter backwash.
Lighting control:
- By programming on a 24h cycle.
Control of a salt chlorinator (or a dosing pump):
- By integrating the information supplied through the RedOx probe.
- Possibility to bring the electrolyser in hibernation at temperatures below 15°C, to prevent premature wear
of the electrodes.
Control of heating (heat pump, electric re-heater, heat exchanger, etc.):
- By incorporating information from the integrated temperature sensor.
Control of an AUX1 outlet:
- Possibility of controlling a pH dosing pump, or a cleaning robot, or a fountain, etc.
- By programming on a 24h cycle (excluding the pH pump).
MAESTRO also makes it possible to visualise, on its screen (in the technical room):
- Instant information from the pool (pH, RedOx, conductivity, water temperature, radio signal strength) as well
as from the previous 64 days.
- The daily functioning durations of filtration, of the electrolyser, of the heating and the AUX1 outlet as well as
those of the 64 previous days.
MAESTRO also provides information on the current status of the outlets (open/closed) and allows, via 4X
extension, various options to be added (peristaltic pump, sensors, inlet or outlet extension).
Therefore, in summer and winter, you no longer need to worry about your filtration and you limit the interventions
in the technical room to a bare minimum.
Functions