LEGEND
®
INSTALLATION MANUAL
E. Cutting the Feed Hose
- (cont.)
8. When cutting hoses, please use strong scissors
or a sharp knife. Be sure to slide the floats out of
the way when cutting hose.
9. Put extra mender nut on the Legend
®
mast and
push soft hose gently over mast at 1/2", turn
mender nut around soft hose tight.
Note: The Back-Up Valve still should be 30"
(76 cm) from the head of the cleaner.
10. Now take the bag, 360002/360009, out of the
box and firmly twist lock bag onto the top of
Legend
®
throat over rubber debris valve.
11. Review and check list: White and soft hoses
cut properly and floats evenly spaced. Mender
nuts tight around swivels, Back-Up Valve,
Legend
®
mast and wall fitting. Make sure wall
fitting is securely locked into place.
12. Lower your complete Legend
®
assembly into your pool carefully.
It should look like the Figure-right.
13. Go back to your equipment and
turn filter pump on first (wait 30
seconds to force air out of the
hose), then turn booster pump on.
14. For adding additional feeder hose
for large pools requiring more
hose length you will need to
purchase one (1) additional hose
(LLD45/LLD45PM), four (4) floats
(ED10P/LLD10PM), one (1)
swivel (ED05/LLD05PM), and
two (2) mender nuts (ED15/LLD15PM). Attach extra white (hard) hose between soft hose and existing
white (hard) hose, using floats, swivel and mender nuts. Divide extra white (hard) hose overage by
three (3) this time to keep all white hoses the same length.
FEED HOSE
MENDER NUT
FEED MAST
RUBBER
DEBRIS VALVE
FIRST
SWIVEL
SECOND
SWIVEL
THIRD
SWIVEL
SHORT
WHITE
HOSE
LONG
WHITE
HOSE
LONG
WHITE
HOSE
BACK UP
VALVE
SOFT
HOSE
12
[English]
