LEGEND
®
INSTALLATION MANUAL
G. Fine Tuning the Legend
®
- (cont.)
3. Checking Wheel RPM
To determine whether the Legend
®
is receiving the proper
water pressure, turn off the pool pump, and carefully
remove the Legend
®
from the pool.
Mark the front drive Tire/Wheel with a marker, or use
the Pentair logo located on the side of tire as a marker
to count the rotations of the wheel per minute.
Have someone turn on pool pump and the booster pump
while you place the Legend
®
in the pool just beneath
the water surface. (Be sure to hold onto the Sweep Hose
to avoid getting wet).
Count the rotations of the marked wheel for exactly one
minute. (Be sure the Back-Up Valve isn't cycling at this
time). The rotations will give you the Revolutions Per
Minute – (RPM).
For proper performance, the Legend
®
operates between
28-32 RPM. If the RPM is below 28 then call your local
Pool Professional or contact our Technical Support
Department at 1-800-831-7133 [USA] or {Herentals – B32 (0) 14.25.99.11}.
If the RPM is more than 32, at the Wall Fitting, unscrew the Pressure Relief Valve slowly until the RPM
falls between 28-32.
If you have any additional questions, please contact Pentair Water Pool and Spa, Inc., Technical
Support Department at:1-800-831-7133 [USA] or {Herentals – B32 (0) 14.25.99.11}, Monday
through Friday.
III. Operation/Periodic Maintenance
A. Connecting/Disconnecting the Legend
®
Turn off the booster pump and pool pump. Then take the Wall Fitting and twist lock the Wall Fitting
clockwise into the Wall Adapter. To disconnect the Legend
®
, unlock and twist counter-clockwise. The
Wall Adapter should remain in the pool wall.
B. Turning On/Off the Legend
®
The Legend
®
operates off the booster pump coming from the equipment pad, and can be turned on or off
by merely turning on/off your booster pump time clock.
SWEEP
HOSE
FRONT
WHEEL
DRIVE
14
[English]
