LEGEND
®
INSTALLATION MANUAL
F. Checking Operation
When operating correctly, the Legend
®
will travel in a random pattern throughout the pool, vacuuming
and sweeping the bottom. The climbing ability of the Legend
®
is dependent on the pools structure and
water flow coming into the pool. It will perform more efficiently in pools without sharp angles or curves in
the transition from the floor of the pool to the wall.
The Legend
®
comes with a Twist Lock Pressure Relief Valve (Wall Fitting). If the Legend
®
is receiving too
much water pressure, the Relief Valve in the Wall Fitting will release the excess water pressure.
Approximately every three minutes and 30 seconds the Legend
®
will go into a back-up mode. The
Back-Up Valve cycle time, while in the back-up mode, is approximately 30 seconds, pulling the Legend
®
from it’s current location increasing it’s random pattern.
New Back-Up Valve Information:
The Back-Up Valve Insert which slides into the slot over
the jet of the valve. This is secured with a stainless steel
screw as shown in the diagram. The insert will be set from
the factory with the larger (3/8") [0.9525 cm] hole over the
opening of the jet. The larger hole is used for the Legend
®
cleaner. If you change the insert to the smaller (1/4")
[0.635 cm] hole, the Back-Up Valve will have increased jet
pressure and possibly tangle your hose.
The Sweep Hose operates in a gentle sweeping motion to
prevent debris from becoming trapped in hard to reach
corners of the pool.
If the Legend
®
does not travel to all areas of the pool, turn
off the booster pump and pool filtration pump and make the
necessary adjustments from the instructions in the next
section.
G. Fine Tuning the Legend
®
1. Thrust Jet Adjustment
There is a Thrust Jet located in the back of the Legend
®
. This
Thrust Jet alters the direction of the cleaner. The factory
standard position for the jet is set in the middle and straight
out. (See illustration – right.)
2. Sweep Hose Adjustment
The Sweep Hose operates in a gentle sweeping motion. To
increase or decrease the motion of the Sweep Hose, adjust
the screw which is located on the Feed Mast Barb below the
Ballast Float. Turning the screw clockwise will decrease the
motion and counter-clockwise to increase the motion of the
Sweep Hose.
Insert
Screw
Back-Up Valve
[English]
13
