EnglishEnglishEnglish
Section 3
IntelliComm® II Interface Adaptor Connections
Screw terminal
: Connects to the pump via a two pin 15 m communication cable (P/N 350122) provided with the pump. Also connects
to a 9-24VDC, 200mA power source (automation control system circuit board)
IntelliComm II
Interface Adapter
Four (9 - 24V DC/AC) input terminals (m³/h - RPM 1, 2, 3, 4)
: Each input terminal
connects to an output relay or valve terminal on the automation control system
circuit board via a two-pin AUX cable.
LED on when power (9-24V DC) is received from automation system.
Power LED on when power is applied.
Connecting to IntelliComm II Input Program Terminals
There are four (two-wire) cables provided in kit for interface connections from the automation control system circuit board, to the four
IntelliComm II program (m³/h - RPM) input terminal. The input terminal cable wires are not polarized. Plugs/wires can be connected
in any order.
Connecting IntelliComm II to a Valve Actuator
A Valve Actuator can be connected from the automation control system circuit board to any one of the IntelliComm II input terminals
(1-4) by splicing into the valve actuator cable using the provided two-wire input terminal cable.
Connecting Power (9-24 VDC) to IntelliComm II
Power to the IntelliComm II requires a 9-24VDC, 200mA power source, which can be supplied from the automation control system
circuit board or an AC to DC power adapter.
IntelliFlo pump AC connection
If multiple pump speeds are required, the IntelliFlo pump must be wired to a circuit breaker not to a relay.
Note
: If the IntelliFlo pump is used in a commercial application or connected to an Emergency Shut-Off switch, the pump must be
connected to a relay for proper Emergency Shut-Off operation.
Salt Chlorine System Connections
All Salt Chlorine Generator (SCG) units must be connected to the Filter Pump relay output.
4