Cyclone Universal & Cyclone Universal FX - User Manual
58
•
Up Arrow Click - Counts the serial number up.
•
Down Arrow Click - Counts the serial number down.
11.2.5
Hex Upper Bounds
There is one display column for each upper bound of the byte in the serial number in hex.
•
Up Arrow Click - Increases the upper bound by one with a maximum of FF Hex.
•
Down Arrow Click - Decreases the upper bound by one with a minimum of the current
serial number byte value.
•
Double Click on Hex - Selects or de-selects the byte column. Selected shown in yellow.
The serial number byte in this column may then be modified using the buttons at the
bottom of the Serialize utility. Please refer to
Section 11.2.11 - BINARY, NUMERIC,
CONSTANT, ALPHA UPPER, ALPHA LOWER, and PRINTABLE
.
11.2.6
Hex Lower Bounds
There is one display column for each byte of the lower bound of the serial number in hex.
•
Up Arrow Click - Increases the lower bound by one with a maximum of the current serial
number byte value.
•
Down Arrow Click - Decreases the lower bound by one with a minimum of 00 Hex.
11.2.7
NEW
Instructs the program to start editing a NEW (as yet un-named) serial number file. It will throw
away the information for any serial number currently being edited unless that information has been
saved (Save Button). The new serial number is initialized with one (1) byte of binary.
11.2.8
SAVE
Instructs the program to save the current serial number being edited into the file name and path
shown in the Serial Number File window. If a file name has not been provided, i.e. the window
shows None Selected, then an error is displayed in a red window on the screen. If this happens,
type in a filename in the window and click Save again.
11.2.9
HELP
Opens the Serialize help system (serialize.hlp file, i.e. this file) for perusal.
11.2.10
QUIT
Turns off the Serialize Program and saves any setup information in the file Serialize.ini. This file
will initialize the setup information the next time the program is started. Xing out of the program
(top right of screen) does not save the setup info.
11.2.11
BINARY, NUMERIC, CONSTANT, ALPHA UPPER, ALPHA LOWER, and PRINTABLE
These buttons are used to set the properties of selected (colored yellow) bytes of the Serial
Number. Individual bytes whose properties you wish to modify are selected or deselected by
double-clicking in the Hex Upper Bounds box in the column that corresponds with the values for a
particular byte.
11.3
Serialize Utility Example
This example shows:
1. Currently editing file C:\Example.ser
2. Number of bytes in the serial number is 10 Hex (= 16 base ten)
3. Starting address is 0000000 Hex
4. Next Serial number is AAA-P&E-9999 in ASCII
